 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 55-8145-203-13&P
1
(2) Remove all short carriers (1) and long carriers (2). The
right-hand door has carriers on all four door edges. The
left-hand door does not have a carrier or seal on the edge
3
that mates with the right-hand door.
(3) Remove and discard all seals (3).
2
(4) Using a 3/16" drill bit drill out rivets (1). There are
seven rivets on each top and bottom edge and 14 rivets
on each side edge. The left-hand door does not have
2
rivets on the edge that mates with the right-hand door.
(5) Remove all short carriers (2) and long carriers (3). The
right-hand door has carriers on all four door edges. The
left-hand door does not have a carrier or seal on the edge
that mates with the right-hand door.
b. Installation
1
NOTE
-
Perform Steps 1 through 31 for Model ESETC-01.
-
Perform Steps 32 through 55 for Model 101.
3
(1) Using a pencil, mark the positions on the carriers where
the new rivets will be installed. Proper location for the
holes for the short and long carriers is as follows:
NOTE
45 MM
The dimensions given below are approximate. The goal
(4 PLACES)
of the steps is to mark the spot where the rivets will be
21 MM
21 MM
installed. It is important that the desired number of spots
are shown. It is not a problem if the spacing between the
spots is not uniform. Some marks may need to be
moved slightly in order to avoid existing nail (or rivet)
TOP AND BOTTOM CARRIERS (SHORT)
locations.
208 MM
Make sure the marks are centered as much as possible
(8 PLACES)
between the edges of the carriers.
25 MM
25 MM
(a)
For the short carriers, mark a spot approximately
21 mm (0.83 inches) from each end. Then mark
four more spots approximately 145 mm (5.7
inches) apart. Each carrier should have six spots
EDGE CARRIER (LONG)
fairly equally spaced.
(b)
For the long carriers, mark a spot approximately
25 mm (1 inch) from each end. Then mark eight
more spots approximately 208 mm (8.18 inches)
apart. Each carrier should have 10 spots fairly
equally spaced.
5-8
Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals