DOCUMENT HOLDER, REPLACE.

TM 55-8145-203-13&P

4.8 DOCUMENT HOLDER, REPLACE.

This task covers: a. Removal b. Installation

INITIAL SETUP

Tools

Equipment Condition

7/16 inch socket wrench (Appendix B, Section III, Item 5)

Right-hand door is open.

Caulking gun (Appendix B, Section III, Item 3)

Both document holder doors are raised.

Materials/Parts Required

Personnel Required

None

a. Removal

NOTE

Perform Steps 1 through 8 for Model ESETC-01.

Perform Steps 9 through 12 for Model 101.

(1) Place 7/16 inch socket over one of the bolts (1) on the outside document holder (2).

(2) Use another 7/16 inch socket to remove the corresponding nut (3) on the inside document holder (4).

(3) Repeat Steps (1) and (2) at the three remaining attachment points.

(4) Remove inside document holder (4), being

careful not to lose the nine washers (5) that are on

the lower bolts and the seven washers (6) that are

on the upper bolts.

NOTE

If only inside document holder is being

replaced, proceed to installation procedures. If

outside document holder is being replaced,

continue with this procedure.

(5) Remove seven washers (6) from each of the

upper bolts.

(6) Remove nine washers (5) from each of the lower

bolts.

(7) Remove all four bolts (1) and washers (7) from

the outside document holder (2).

NOTE

Outside document holder (2) may remain

adhered to door by beads of silicone.

(8) Remove outside document holder (2) from door.

Change 1

4-5