Chapter 2. OPERATOR INSTRUCTIONS - TM-55-4920-439-13-P0014

TM 55-4920-439-13&P

CHAPTER 2

OPERATOR INSTRUCTIONS

SECTION I. INITIAL SHOP SETUP

2-1. Setup of Electric/Instrument Shop upon initial receipt. Refer to TM 10-5411-201-14 for specific procedures

concerning erection of the tactical, one side expandable, shelter (NSN 5411-01-124-1377).

a. The Electric/Instrument Shop should be set up with power cable length, tactical deployment, exhaust/inlet of

ECUs and phasing between related shops kept in mind. The shop's power entry panel, next to the personnel entrance

door, should be facing toward the power source and power distribution panel (see page 1-0).

Initial Leveling. Procedures in TM 10-5411-20-14 will be followed to ensure proper operation of all fold out panes.

WARNING

When all equipment and materiel is stored on the stationary side of the shelter, the

limited floor space presents a safety hazard to operating personnel. This is most

critical during the raising and lowering of the roof panel. Failure to observe

supplemental instructions could result in serious injury to personnel. Personnel

inside the shelter could become trapped between the roof panel and equipment

bolted to the floor.

Supplemental Safety Instructions. To prevent possible accidents, the following procedures will be followed:

1. Two personnel, outside the shelter, must lift

the roof panel (1) far enough to allow two people inside

to release the support struts (2), extend them to full

length, and insert the quick-release pins (3).

Change 1 2-1