Figure 4-41. Cylinder Liner Mounting in Block.

TM 55-1930-208-24

Figure 4-41. Cylinder Liner Mounting in Block.

(4) Install a cylinder liner hold-down clamp as shown in figure 4-42.

Figure 4-42. Checking Distance of Liner Flange Below Top Face of Block.

(5) Measure distance from top of liner to top of block with a dial indicator. The liner flange must be .045 inch to

.050 inch below the surface of the block. However, even though all of the liners are within these

specifications, there must not be over .002 inch difference in depth between any two adjacent liners when

measured along the cylinder longitudinal center line.

4-53