Table 4-1. Cylinder Liner Tolerances

TM 55-1930-208-24

4-12. CYLINDER LINERS - Continued.

c. Inspection - Continued.

Table 4-1. Cylinder Liner Tolerances

d. Installation.

(1) Wipe the inside and outside of the liner clean and make sure the block bore and counterbore are clean.

(2) Place a standard size cylinder liner in the cylinder block as shown in figure 4-41.

(3) Push cylinder liner into the cylinder block until the liner flange rests on the insert. Do not use excessive force to

install liner. The liner should slide smoothly in place with hand pressure. If a new liner cannot be pushed in

place, light honing of the block bore may be necessary to obtain the desired fit for best heat transfer.

4-52