 |
|||
|
|
|||
|
Page Title:
Figure 4-39. Cylinder Liner Measurement Diagram |
|
||
| ||||||||||
|
|
 TM 55-1930-208-24
(e) After honing, the liner must conform to the same limits oil taper and out-of-round as a new liner and the piston-to-
liner clearance must be within the specified limits.
(4) Measure the block bore (figure 4-39) and the outside diameter of the liner. If the liner-to-block clearance (with used
parts) exceeds .0025 inch, it will be necessary to bore the block for an oversize liner.
Figure 4-39 .
Cylinder Liner Measurement Diagram .
4-49
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals