CYLINDER LINERS.

TM 55-1930-208-24

4-11. PISTONS AND CONNECTING RODS - Continued.

g. Installation - Continued.

(13) Check connecting rod side clearance. The clearance must be .006 inch to .012 inch.

(14) Install the remaining piston and rod assemblies in the same manner. Use hold-down clamps to hold each

liner in place.

(15) After all of the liners and pistons have been installed, remove the hold-down clamps.

(16) Refer to paragraph 3-37 and install oil pan.

(17) Refer to paragraph 3-38 and install cylinder head.

4-12. CYLINDER LINERS.

This task covers:

Removal

Cleaning

Inspection

INSERT FUNCTION

INITIAL SETUP:

Tools Required:

Tool Kit, General Mechanics (Item 1, Appendix B)

Cylinder Liner Remover Set (Item 61, Appendix B)

Cylinder Hone Set (Item 62, Appendix B)

Stones and Wipers (Item 63, Appendix B)

Gage, Bore, Dial (Item 64, Appendix B)

Master Ring Gage (Item 65, Appendix B)

Cylinder Set, Master Range (Item 66, Appendix B)

Clamp (Item 68, Appendix B)

Fixture, Bore Ring Master Set (Item 69, Appendix B)

Materials Required:

Oil, Fuel (Item 9, Appendix C)

Equipment Conditions:

Engine shut down (paragraph 2-11, TM 55-1930-208-10).

Cylinder head removed (paragraph 3-38).

Pistons and connecting rods removed (paragraph 4-11).

a. Removal.

(1) Remove cylinder liner with tool J1918-02 as follows.

4-46