INTAKE, AIR CLEANER ASSEMBLY. - TM-55-1930-208-240093

TM 55-1930-208-24

3-18

INTAKE, AIR CLEANER ASSEMBLY.

This task covers:

a. Removal

b. Disassembly

c. Cleaning

d. Inspection

e. Repair

f. Reassembly

g. Installation

INITIAL SETUP:

Tools Required:

Tool Kit, General Mechanic's (Item 1, Appendix B)

Wrench, Torque (Item 71, Appendix B)

Materials Required:

Gasket P/N 3290612

Ring P/N 5182977

Solvent, Cleaning (Item 4, Appendix C)

Washer, Lock P/N MS35338-46

Equipment Conditions:

Engine shut down (paragraph 2-11, TM 55-1930-208-10).

Air cleaner removed (paragraph 3-15, TM 55-1930-208-10).

Air shutoff cable disconnected (paragraph 3-6).

Ether starting aid disconnected (paragraph 3-23, TM 55-1930-208-10).

Engine shutdown removed (paragraph 3-6).

Removal. (Refer to figure 3-25).

(1) Remove four screws (1) and four lockwashers (2) and remove the air inlet housing (3) from the

side of the blower.

(2) Remove striker plate gasket (4) and striker plate (5).

Disassembly.

(1) Use a small punch to remove pin (6) and flat washer (7) from the air shutoff valve shaft.

Remove and discard the seal ring (8) from the housing.

(2) Remove two pins (9) that secure the air shutoff valve to the shaft.

(3) Note the position of the air shutoff valve spring (10) and valve (11). Then, withdraw the shaft (12)

from the housing to release the valve and spring in the housing. Remove and discard the seal

ring (13) from the housing.

(4) Remove the screw (14), lockwasher (15), and flat washer (16) from the housing and remove the

latch (17), latch spring (18), and bushing (19).

(5) Remove lever handle (20) and lever control cam (21) from the housing.

3-56