|
|
TM 55-1905-223-24-4
a. Position the head gasket (4) over holes on block. Gasket is marked "TOP."
CAUTION
Be sure the gasket is correctly aligned with holes in the block.
b. Carefully put the. cylinder head (3) on the block and seat it onto the gasket.
c.
Replace capscrews (1, 2.) finger tight.
d. Install rocker levers, paragraph 2-38.
e. Tighten capscrews in sequence as illustrated in FIGURE 2-40. Torque in three steps as follows.
STEP
TORQUE VALUE
1
29 ft-lb (40 N )
m
2
62 ft-lb (85 N )
m
3
92 ft-lb (126 N )
m
NOTE
For coolant mixture, refer to TB 55-1900-207-24.
f.
Replace coolant.
FIGURE 2-40. Torque Sequence.
2-103
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |