Chapter 4. INTERMEDIATE GENERAL SUPPORT MAINTENANCE INSTRUCTIONS

TM 55-1905-223-24-17

CHAPTER 4

INTERMEDIATE GENERAL SUPPORT MAINTENANCE INSTRUCTIONS

Page

Section I.

Repair Parts, Special Tools; Test, Measurement, and Diagnostic

Equipment (TMDE); and Support Equipment ................................................. 4-1

Section II.

Service Upon Receipt.................................................................................... 4-1

Section III.

Intermediate General Support Preventive Maintenance Checks and

Services (PMCS)........................................................................................... 4-2

Section IV.

Intermediate General Support Troubleshooting.............................................. 4-2

Section V.

Intermediate General Support Maintenance Procedures ................................ 4-13

Section VI.

Preparation for Storage or Shipment ............................................................. 4-77

SECTION I. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT,AND DIAGNOSTIC EQUIPMENT

(TMDE); AND SUPPORT EQUIPMENT

4-1.

Common Tools and Equipment. For authorized common tools and equipment, refer to the Modified

Table of Organization and Equipment (MTOE) applicable to your organization.

4-2.

Special Tools, TMDE, and Support Equipment. Special tools; test, measurement, and diagnostic

equipment; and support equipment requirements are listed and illustrated in the Repair Parts and Special Tools

List (RPSTL), TM 55-1905-223-24P. These items are also listed in the Maintenance Allocation Chart (MAC),

Appendix B of this manual.

4-3.

Repair Parts. Repair parts are listed and illustrated in the Repair Parts and Special Tools List (RPSTL),

TM 55-1905-223-24P.

SECTION II. SERVICE UPON RECEIPT

4-4.

Checking Unpacked Equipment.

a. Inspect the equipment for damage incurred during shipment. If the equipment has been damaged,

report the damage in accordance with the instructions of DA Pam 738-750.

b. Check the equipment against the packing slip to see if the shipment is complete.

Report all

discrepancies in accordance with the instructions of DA Pam 738-750.

Check to see whether the equipment has been modified.

4-1