ATTACHING TRANSPORTER ASSEMBLIES TO SHELTER OR CONTAINER

TM 55-1740-203-13&P

2-8. ATTACHING TRANSPORTER ASSEMBLIES TO SHELTER

OR CONTAINER.

(Refer to Figure 2-4).

A t t a c h t h e f r o n t a n d r e a r t r a n s p o r t e r assemblies to a s h e l t e r o r c o n t a i n e r

a s follows:

Uncouple

t r a n s p o r t e r f r o m tow vehicle and apply h a n d b r a k e .

WARNING

To prevent injury to personnel a minimum of

two persons are required to disconnect front

and rear transporter assemblies.

D i s c o n n e c t the safety cable from the rear transporter assembly, mak-

ing sure safety cable remains attached to front transporter assembly.

Block wheels of rear transporter assembly to prevent rolling.

D i s c o n n e c t front and rear assemblies by removing two nuts, six

washers, and two bolts from tine assemblies.

Aline transporter assemblies so that their front tines are directly in

line with the outer tine brackets of the shelter or container.

Disconnect lockout struts by removing T-pins from top of strut.

Pivot lockout struts away from transporter tines.

Figure 2-4.

Attaching Transporter to Container or Shelter.

2-13