Figure 3-37. Lift Cylinders.

TM55-1730-228-13&P

3-35. LIFT CYLINDERS - REPLACE (Continued)

3-35

(4) Remove fittings (5) from c ylinder ports. Install plugs in ports and hoses to prevent foreign matter from entering

the system.

(5) Remove four bolts (6) with washers. Remove hold valve (7) from cylinder (8) and allow to hang.

(6) Remove and discard preformed packings (not shown) between hold valve (7) and cylinder (8).

Figure 3-37. Lift Cylinders.

(7) Remove two roll pins (1, Figure 3-37) from the cylinder end retaining pins (2).

(8) Remove two roll pins (3) from the rod end retaining pins (4).

Support the cylinder by strapping the rod end to the scissors when removing the eye pins.

(5) Remove the cylinder eye pins (2 and 4) with a 3/4" brass drift and hand sledge one at a time while helper

supports cylinder.

(6) Remove the cylinder (5).

GO ON TO NEXT PAGE

3-89