Figure 3-36. Lift Cylinders Replacement (Sheet 2 of 2).

TM 55-1730-228-13&P

3-35. LIFT CYLINDERS - REPLACE (Continued)

3-35

Figure 3-36. Lift Cylinders Replacement (Sheet 2 of 2).

a. REMOVAL:

WARNING

Some hoses may contain small amounts of trapped hydraulic pressure. Wear protective clothing including a face shield,

head gear and gloves. Fine streams of hydraulic fluid under pressure cannot be readily seen but can easily penetrate the

skin causing severe personal injury. Use extreme caution and be alert whenever breaking into a hydraulic system.

WARNING

Hydraulic fluid may be extremely hot. Allow the SPEMS to stand fifteen minutes before breaking into hydraulic system.

(1) Tag cylinder ports and valve hoses for ease of identification during installation.

(2) Using two wrenches, disconnect cylinder hoses (1, Figure 3-36), hold valve hydraulic hoses (2) and solenoid

connectors (3). Drain waste hydraulic fluid into a drip pan.

(3) Remove elbow and tee fitting (4).

GO ON TO NEXT PAGE

3-88