 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 --. Cleaning and Inspection.
b
moval of l/8-inch pipe plug (B-1) and replace-
ment of the four 7/16 x 1-7/8 plain studs (B-3).
Remove pipe plug from air compressor support
(1) Cleaning. Clean air compressor support
following instructions on figure 349.
assembly (B) as directed in para-
graph 152c.
(2) Inspection. Figure 350. (A) Inspect the
plain studs for strip-
four
ped threads and for looseness in sup-
port. (B) Inspect oil inlet hole in com-
pressor mounting gasket face for
obstructions. Use a wire probe to clean
out oil hole, pushing probe through and
out oil inlet hole in support gasket sur-
face (fig. 349). Clean out oil hole, after
probing, with compressed air. (C) In-
spect gasket surface for nicks, sticking
gasket material, and damage.
c . Repair. Repair air compressor support
assembly as directed in paragraph 154b.
R e p l a c e damaged studs (B-3) as directed in
port if cracked or when stud holes are stripped
or elongated.
PIPE PLUGS IN AIR COMPRESSOR SUP-
d. Assembly. Install 1/8-inch pipe plug (B-1)
PORT ASSEMBLY.
in air compressor support assembly as shown
in figure 349.
Note. The key letters shown below in paren-
theses refer to figure 322 except where other-
wise indicated.
--. Cleaning and Inspection.
a
(1) Cleaning. Clean tappet chamber cover
(X) directed in paragraph 152c.
(2) Inspection. I n s p e c t t a p p e t c h a m b e r
cover (X) as directed in paragraph 153b.
surface must be clean and
smooth.
b . Repair. Repair tappet chamber cover (X)
a s directed paragraph 154b. Remove raised
m e t a l from cover gasket surface using a fine
mill file.
SUPPORT.
216
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals