Figure 5-182. Removing starter and/or generator idler gearshaft.

Remove

1. Cut locking wires (A).

2. Remove two slotted nuts (B) attaching starter

idler

gear shaft to crankcase.

3. Remove two slotted nuts (C) attaching generator

idler

gearshaft to crankcase.

Install

idler

1. Install two slotted nuts (C) securing generator

gearshaft to crankcase.

idler

2 . Install two slotted nuts (B) securing starter

gearshaft to crankcase.

3. Install locking wire (A) securing slotted nuts.

Remove

Figure 5-181. Removing or installing starter

1. Cut locking wire (A).

2. Remove six slotted nuts (B) attaching starter driven

and

generator

idler

gearshaft

flange

nuts.

gearshaft bearing cage to crankcase assembly. Install

two 5 / 16-24 jack screws in holes provided in cage.

Alternately tighten jack screws until cage separates

from crankcase.

Install

1. Install six slotted nuts (B) securing starter driven

gearshaft bearing cage to crankcase assembly.

2. Install locking wire (A) securing slotted nuts.

Figure 5-183. Removing or installing starter

driven gearshaft bearing cage attaching parts.

1. Install mechanical adapter - 5120-837-5091 (A) into

tapped hole provided in end of starter idler gearshaft.

2. Install mechanical puller - 5120-310-4668 (B) into

adapter. Slide hammer on puller against handle to pull

starter idler gearshaft from crankcase assembly.

3 . Support starter idler gear (C) with wooden block

while removing gearshaft and then remove idler gear.

4. Remove and discard preformed packing (D).

Note. The generator idler gearshaft and idler

gear are removed in the same manner as in-

structed for starter idler gearshaft and idler gear.

Figure

5-182. Removing starter and/or

generator idler gearshaft.

5-106