Section XI. OVERHAUL (REBUILD) OF OIL TRANSFER PLATE ASSEMBLY

LEGEND to fig. 5-81.

steps 2 through 5 (fig. 5-84 through 5-87).

5-44.

Cleaning

N o overhaul (rebuild) of such components

Refer to paragraph

5-2

for

cleaning

recom-

is required or recommended.

mendations.

a. I f s p e e d o m e t e r b u s h i n g ( 6 ) w a s r e m o v e d ,

5-45. Inspection and Repair

insert new bushing in bore, and drive in until outer

R e f e r to paragraph 5-3 for general inspection and

e n d is flush with bore face.

repair recommendations. Refer to paragraph 6-3

b. If shift lever sleeve was removed, insert new

a n d table 6-3 for general wear limits information.

sleeve in bore, and drive from outside in until head

5-46.

Assembly

i s seated firmly against bore face.

NOTE

(fig. 5-81)

Outer end of sleeve has a very slightly

NOTE

l a r g e r diameter.

All items not covered in a and b b e l o w a r e

installed as outlined in paragraph 5-58,

Section XI. OVERHAUL (REBUILD) OF OIL TRANSFER PLATE ASSEMBLY

a. Do not remove governor pressure check valve

5-47.

Description

retainer (75) and ball (76) unless replacement is

R e f e r to paragraph 2-11 for description of the oil

necessary.

t r a n s f e r plate assembly.

b. Do not remove slotted spring pin (78) unless

5-48.

Disassembly

r e p l a c e m e n t is necessary.

(fig. 5-82

c. Do not remove drive

screw

(80)

unless

NOTE

r e p l a c e m e n t is necessary.

All items not covered in a through d below

d. R e m o v e t w o c o n v e r t e r r e l i e f v a l v e r e t a i n e r

were removed from the transmission as

s c r e w s (85), and remove retainer (84), spring (83),

o u t l i n e d in paragraph 5-6, steps 8 through

w a s h e r (82), and ball (81) from oil transfer plate

(fig.

5-8

through

5-13).

further

(77).

d i s a s s e m b l y of those parts is required.

5-39