Section XIII. ASSEMBLY OF TRANSMISSION FROM SUBASSEMBLIES

washers (5) in retainer and cover. Tighten screws to

(1) Install spring (43) and throttle regulator

valve (39) in valve body (42).

24 to 36 pound-inches torque.

b. Items Installed in Rear of Control Valve

(2) Install shift valve (38) and spring (36) in

valve body (42).

Assembly.

NOTE

(3) Install front governor valve (41) and main

regulator valve (40) in valve body (42).

When a replacement valve body assembly

(4) Install valve plug (35) and spring (37) in

(3) or valve body (42) must be installed,

front cover (34).

readjustment of throttle valve adjusting

screw (62) is necessary. Refer to paragraph

(5) Install ball (32), springs (31 and 30), and

5-63 for adjustment procedures.

extender valve (29) in front cover (34).

(1) Install shift valve (46) and shift plug (47)

(6) Install extender valve cover (26) and

in valve body (42).

screw (25).

(2) Install shift valve (49) and shift plug (48)

(7) Install three retaining screws (24) and two

in valve body (42).

screws (13), and secure front cover (34) to valve

body (42).

(3) Install shift plug (50) and flOW valve (51)

in valve body (42).

(8) Install two inhibitor valves (18), springs

(15 and 17), and washers (16) into inhibitor valve

(4) Install spring (52) and trimmer stop (53),

large diameter end first.

body (21). Compress washers against springs far

enough to allow installation of dowel pins (19).

(5) Install spring (54) and plug (55).

Drive dowel pins in far enough to allow for staking

(6) Install springs (56 and 57) and trimmer

valve (58), open end first.

of body metal over dowel pins.

(7) Install rear cover (60) and seven screws

NOTE

Do not interchange springs (15 and 17).

(59). Tighten screws to 24 to 36 pound-inches

torque.

These springs have different ratings and

must be installed into their proper bores.

(8) Install throttle valve (44) in valve body

(9) Install two blocker plugs (28) and two

(42).

springs (14 and 27) into front cover (34).

(9) Install throttle valve retainer (64) and

(10) Install inhibitor valve body (21) on front

screws (61 and 63). Tighten screws to 24 to 36

cover, and install screw (20), and four washers

pound-inches torque.

(23), and four screws (22). Tighten screws to 24 to

c. Items Installed in Front of Control Valve

36 pound-inches torque.

Assembly.

Section XIII. ASSEMBLY OF TRANSMISSION FROM SUBASSEMBLIES

5-57. General

c. Exploded Views. See appropriate exploded

view and figures 5-83 through 5-140 for assembly

a. Pictorial Steps. The assembly procedures are

sequence and parts identification.

arranged in successive pictorial steps. Simple in-

d. Tool Information. Refer to paragraphs 3-1

structions a r e given below each procedure

through 3-5 for special and improvised tool in-

illustration. These instructions are keyed to the

form ation.

illustrations by letter callouts.

b. Instructions Before Assembly. Refer to

5-58. Assembly Steps

paragraphs 5-1 through 5-4 for general instructions

before beginning assembly of the transmission.

5-43