Section XI. AIRCRAFT AND AIRCRAFT ITEMS

TM 746-10

Launcher

Tie-down unit

4-127. Ancillary Equipment

Launching control

Tracking station

Accessory kit

Detector radio

Launching station

Trailer

Alignment set

Display set

Loader

Trailer rocket

Antenna mast

Distribution set

Mobility kit

Truck

Azimuth laying

Dolly

Operations station

Azimuth set

Electronic equipment

Battery control

Fault locator

4-130. Preservation and Packing

Blanket

Filler hydraulic

Cable

Firing device

a. Clean equipment per process C-1 as described

Cable set

Hoisting unit

in TM 38-230-1.

Cart assembly

Interconnecting group

b. Accomplish drying, as required, immediately

Charger battery

Jack set

after cleaning by procedure D-4 or D-5.

Console

Kit boom

c. Apply P-10 to those metal surfaces on which

Control box

Kit torque

corrosion in any form would impair the usefulness of the

Control central

Launcher

part or assembly. Preservatives will not be applied to

Control indicator

Launcher monorail

the surfaces of parts or assemblies which are protected

Control set

Main assemblies

with solid film lubricants or assemblies which are

Conversion kit

Modification kit

protected with solid film lubricants or plastic coatings,

Cradle

Rack loading

prime coated or painted, or are vulnerable to damage by

Data converter

Rail launching

contact preservatives.

Ramp set

Test box

d. Package mounted or unmounted equipment

Rotary launcher

Test equipment

cited in this section per guidance in TM 38-230-1 and

Servicing unit

Test kit

paragraph 4-123 herein for the selected submethod II

Shop equipment

Test set

preservation.

Shop set

Test stand

(1) Completely immobilize all miscellaneous

Simulator

Test station

carried equipment using provided locking or securing

Simulator group

Training set

devices.

Place cabinet doors, drawers, and trays

Starter assembly

Truck

provided with locking devices in lock position and

secure with filament reinforced tape. Apply tape with

4-128. Unmounted Equipment

sufficient tension to ensure adherence, and, where

Programmer

Test kit

practical, interlace between locking devices. Place

Shop equipment

Test kit

operating controls in an OFF or NEUTRAL position.

(2) Install missile electronic equipment in

4-129. Mounted Equipment

controlled humidity shelters or vans. To provide this

Acquisition radar

Packaging shop

control, the shelter or van must be a completely sealed

Antenna-receiver

Pallet

unit with the port entry of the free breather the only

Cable

Radar

opening allowing the entry or exit of air. When the

Carrier

Radar set

above has been accomplished, the free breather

Control central

Semitrailer

assembly is ready for installation (fig 4-14 and 4-15).

Data processing

Shop equipment

(3) For fabrication and installation of the free

Director station

Simulator station

breather system refer to paragraphs 4-123d(2) through

Electronics shop

Supply office

4-123d(7).

Handling unit

Test equipment

Intercept aerial

Test station

Section XI. AIRCRAFT AND AIRCRAFT ITEMS

and packing all items. Volume I (38-230-1) provides

4-131. General

guidance for preservation, and Volume II (38-230-2)

a. The preservation and packing guidance

contains approved packing procedures.

Unit and

furnished in this section is applicable to aircraft items

intermediate containers will be considered as exterior

categorized under a generic nomenclature. TMs 38-

containers unless packing is specified for the item.

230-1 and -2 should be used for guidance in preserving

4-60