Federal Supply Code for Manufacturer (FSCM).

TM 9-6625-1989-34P

H-

Reparable item.

When uneconomically

reparable, condemn and dispose at the general support

e. Federal Supply Code for Manufacturer (FSCM). The

level.

FSCM is a 5-digit numeric code listed in SB 708-42

D-

Reparable item. When beyond lower level

which is used to identify the manufacturer, distributor, or

repair capability, return to depot. Condemnation and

Government agency, etc.

disposal not authorized below depot level.

f. Description. Indicates the Federal item name and, if

L-

Reparable item. Repair, condemnation, and

required, a minimum description to identify the item. The

disposal not authorized below depot/ specialized repair

physical security classification of the item is indicated by

activity

level.

the parenthetical entry(insert applicable physical security

classification abbreviation, e.g., Phy Sec C1 (C)-

A-

Item

requires

special

handling

Confidential, Phy Sec C1 (S)-Secret, Phy Sec C1 (T)-

condemnation procedures because of specific reasons(

Top Secret). Items that are included in kits and sets are

i.e., precious metal content,

critical

material

listed below the name of the kit or set with the quantity of

hazardous

material).

Refer

appropriate

each item in the kit or set indicated in the quantity

manuals/directives for specific instructions.

incorporated in unit column. When the part to be used

differs between serial numbers of the same model, the

c. National Stock Number(NSN). Indicates the NSN

effective serial numbers are shown as the last line of the

assigned to the item and which will be used for

description. In the Special Tools List, the initial basis of

requisitioning.

issue (BOI), appears as the last line in the entry for each

special tool, special Test, Measurement, and Diagnostic

d. Part Number. Indicates the primary number used by

Equipment (TMDE), and other special support

the manufacturer (individual, company, firm, corporation

equipment. When density of equipments supported

or Government activity), which controls the design and

exceeds the density spread indicated in the BOI, the total

characteristics of the item by means of its engineering,

authorization is increased accordingly.

drawings, specifications, standards, and inspection

requirements to identify an item or range of items.

g. Unit of Measures(U/M). Indicates the standard of

the basic quantity of the listed item as used in performing

the actual maintenance function. This measure is

NOTE

expressed

two

character

alphabetical

abbreviation(e.g., ea, in, pr, etc). When the unit of

When a stock numbered item is requisitioned, the item

measure differs from the unit of issue, the lowest unit of

received may have a different part number than the part

issue that will satisfy the required units of measure will

being

replaced.

be requisitioned.