Section II. LUBRICATION

TM 9-4931-583-30&P

(7) Remove two attaching knobs from lower

2-5. Disassembly.

slider assemblies studs and store in case No. 5. Lift

main frame assembly (18) from frame alignment

a. Disassemble boresight assembly first.

mounting (1). Store frame assembly in case No. 3.

(Figure 1-1.)

(8) Loosen two lower clamp knobs and

(1) L o o s e n t w o T S U - G S E b o r e s i g h t

rotate clamps from behind crossmember.

alignment assembly screws from shelf assembly

a n d remove alignment assembly (21). Store

(9) Loosen handle knobs (5) from over

assembly in case No. 5.

flanges on left and right upper mounting points.

(2) Disconnect left gun optical frame

(10) Lift frame alignment mounting (1)

assembly (8) fitting (7) and remove assembly.

from stand assembly and store in case No. 2.

Store assembly in case No. 4.

b. Disassemble stand assembly. (Figure 2-l.)

(3) Disconnect right gun optical frame

assembly (3) fitting (7) and remove assembly.

(1) Remove shelf assembly (6) from vertical

Store assembly in case No. 4.

support assembly (2) by removing two knobs and

pulling shelf from support. Store shelf in case

(4) Disconnect forward gun optical frame

No. 1.

assembly (15) fitting (7) and remove assembly.

Store assembly in case No. 4.

Disconnect quick release pin (3) from

(2)

each end of brace assembly (4). Remove brace.

NOTE

(3) Disconnect three quick release pins (3)

Main frame assembly must be supported

and lift vertical support assembly (2) from base

after upper frame assembly is

assembly (5).

disconnected.

(4) Store base assembly (5) in case No. 1.

(5) Support main frame assembly (18).

(5) Store vertical support assembly (2) in

(6) Disconnect upper frame assembly (19)

case No. 1.

fitting (7). Lift assembly to separate mounting

bearing from slider assembly stud. Store assembly

(6) Store brace assembly (4) in case No. 1.

in case No. 3.

LUBRICATION

SECTION II.

2-6. General.

Lubrication is required only for

2-7. Lubrication.

Lubricate two places on each

the casters of the stand assembly. The casters will

front caster and one place on each rear caster.

be lubricated as required.

Wipe off excess grease from around caster axle.

Expendable Supplies and Materials List

Part No./

Nomenclature

Specification

Grease

MIL-G-25537

SECTION III. PRE-EMBARKATION INSPECTION OF MATERIEL IN UNITS

ALERTED FOR OVERSEAS MOVEMENT

NOTE

Refer to Section I for

Inspection/Servicing procedures.

2-9