 |
|||
|
|
|||
|
Page Title:
INSTALL CENTER HOUSING, HEAT SHIELD, AND COMPRESSOR HOUSING |
|
||
| ||||||||||
|
|
 TM 9-2990-206-34&P
ASSEMBLY--Continued.
7. On turbine wheel hubs that cannot be
held with a box wrench (because of
factory balancing), use improvised
holding fixture (A) to keep turbine
wheel from turning. Install
compressor wheel (B) and nut (C) and
torque tighten as in steps 4 through
6 above.
INSTALL CENTER HOUSING, HEAT SHIELD, AND
COMPRESSOR HOUSING
TOOLS :
9/16 inch, 1/2 inch drive socket
7/16 inch, 1/2 inch drive deep socket
Socket wrench handle (speeder)
1/2 inch drive, O to 300 pound-
inches, torque wrench
NOTE
Table 3-1 provided information
for proper indexing of the tur-
bine and compressor housings
according to engine model and
mounting location. Table 3-1
applies to both "clean air"
and standard turbosuperchargers.
INSTALLATION:
1. Place turbine housing (A) on bench
with studs down.
2. Aline alinement marks scribed during
disassembly and install center
housing (B) on turbine housing (A).
If alinement marks cannot be located,
or if either housing has been
replaced, refer to Table 3-1 to
determine proper housing position.
TA293549
Change 1
3-23
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
|
|
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
|
Click
here for thousands of PDF manuals
