Install spacer - TM-9-2920-257-30-P0052

TM 9-2920-257-30&P

(k) Install spacer (25) on shaft of rotor (14), all the way down

against bearing. (23).

(6) Install outer seal in drive end housing assembly (fig. 3-1).

(a) Apply a thin film of grease (item 4, App B) to lips of outer

P l a c e seal in position on seal bore of drive end housing

seal (24).

See figure 3-8 for proper seal

assembly (21) with seal lips flaring up.

lip position.

(b) Using a plastic mallet, gently tap outer seal (24) in seal

bore until it is flush with outside surface of drive end housing assembly

(21).

(7) Install inside seal and outer seal on anti-drive end housing

(a) Remove anti-drive end housing (9) from generator assembly.

(b) Place anti-drive end housing (9) in arbor press with external

side of housing resting on base of press.

NOTE

I n n e r seal in anti-drive end housing is to be assembled so

that seal lips flare inward toward rotor.

seal

(10).

Place seal in position on the seal bore of anti-drive end

housing (9) with seal lips flaring inward, toward rotor (14). See figure

3-8 for proper seal lip position.

3-22