Install stator to drive end housing assembly

TM 9-2920-257-30&P

NOTE

W h i l e applying grease, use finger to form the seal lips of inside

seal as shown in figure 3-8.

( d ) A p p l y t h i n f i l m o f g r e a s e ( i t e m 4 , A p p B ) tO l i pS o f i n s i d e

seal.

(3) Install stator to drive end housing assembly (fig. 3-1).

NOTE

A l i n e locator pin in drive end housing assembly with matching

hole in stator.

(a) Place stator (19) in anti-drive end housing (9) so that

s t a t o r l a m i n a t i o n s f i t f l u s h i n p i l o t b o r e o f a n t i - d r i v e e n d h o u s i n g to

protect

stator

windings.

(b) Place terminal block insulator (20) onto stator terminal studs

so that hex cavities of insulator fit over hex portions of studs.

NOTE

Aline stator locator pin with matching hole in drive end

housing.

t h r e e stator terminal studs pass through three holes in housing and

s t a t o r locator pin meshes with matching hole in drive end housing

assembly.

3-17