Remove stator

TM 9-2920-257-30&P

WARNING

While the rotor is being pressed out of the drive end housing

assembly, firmly grasp bottom section of rotor shaft to prevent

rotor from dropping.

Failure to do this could result in injury

t o personnel and damage to equipment.

(b) Apply pressure on top of rotor shaft to remove rotor (14) from

drive end housing assembly (21).

(8) Remove stator (fig. 3-1).

(a) Remove stator (19) and drive end housing assembly (21) from

arbor

press.

Place assembly on top of antidrive end housing (9) so that

d r i v e end housing assembly (21) faces up and stator laminations fit flush

in pilot bore of anti-drive end housing to protect stator windings.

(b) Remove three rectifier leads from stator terminal studs, and

bend leads out of the way to provide access to stator terminal nuts.

stator teminal studs.

(d) Remove three rectifier leads from stator terminal studs, and

bend leads out of the way to provide access to teminal insulator (18).

(e) Remove three nuts (15), washers (16), and six spring washers

(17) used to secure insulator (18) to stator terminal studs.

(f) Remove insulator (18) from stator terminal studs.

3-10