Generator model 30B95-3-C

TM 9-2920-252-34&P

3-10. ASSEMBLY (CONT)

4. GENERATOR DRIVE SHAFT (cont)

f. Prevent rotation of retainer screw (4) with a

screwdriver while installing:

(1) Self-locking nut generator model 30B95-3-

-or

(2) Two plain nuts (8) generator model 30B95-

3-C [shown].

The self-locking nut or inner plain nut must

be tightened until about half the thickness of

special washer remains outside (3/32 inch

still shows) end of drive shaft.

g. Generator model 30B95-3-C - torque outer plain

nut against inner plain nut to 15-20 lb-in [1.7 to

2.3 N ].

NOTE

Adapter plate and clamp which secure

it to housing will be installed during

packaging of generator. Paragraph 3-

11 describes general procedure.

TA315017

3-18