GENERATOR DRIVE SHAFT. - TM-9-2920-252-34-P0034

TM 9-2920-252-34&P

3-10. ASSEMBLY (CONT)

4. GENERATOR DRIVE SHAFT.

a. Apply a light film of grease to short spline of drive

shaft assembly (1).

b. Put shaft retaining plate (2) in position on rotor

shaft (3).

Engage head of shaft retainer screw (4) in

keyhole (5) in rotor bore of generator.

c. Hold retainer screw (4) engaged while sliding

drive shaft assembly (1) onto screw (4).

Alinement of drive shaft with rotor bore will keep

screw in narrow part of keyhole even though

screw may move into rotor slightly until bottomed.

d. Rotate drive shaft (1) as necessary for alinement

of splines as shaft is moved fully into position.

e. Install drive shaft pressure spring (6) and special

washer (7) onto outer end of the retainer screw

(4).

TA315016

3-17