|
|
TM 9-2920-252-34&P
CHAPTER 1
INTRODUCTION
SECTION I. GENERAL INFORMATION.
1-2. DS/GS ALLOCATIONS.
1-1. SCOPE.
a. Type of Manual. This technical manual contains
Refer to maintenance allocation chart in TM 9-2350-258-
instructions for Direct Support and General Support
20 for the assignment of maintenance functions.
(DS/GS) maintenance of Bendix Models 30B95-3-B and
30B95-3-C Generator Assemblies, Bendix Model-24B30-
3-B Regulator Assembly, and Electro-Tech Model 1300
1-3. MAINTENANCE FORMS AND RECORDS.
Regulator Assembly.
Department of the Army forms and records used for
b.- Equipment Identification.
equipment maintenance will be those prescribed by DA
(1) The two models of the 650 ampere
Pam 738-750, The Army Maintenance Management
generator appear quite similar. Model 30B95-3-C has jam
System (TAMMS).
nuts on the input shaft and a jam nut on the oil pump
adjusting screw. Model 30B95-3-B uses a self-locking nut
1-4. REPORTING EQUIPMENT IMPROVEMENT
on the input shaft and has no jam nut on the oil pressure
RECOMMENDATIONS (EIR).
screw.
If your generator or regulator assembly needs
(2) The two regulators are outwardly different
improvement, let us know. You, the user, are the only
in appearance only by a slight case variation. The Bendix
one who can tell us what you don't like about your
regulators, which have a part number 1582488-M circuit
equipment. Let us know why you don't like the design.
card installed, will have a serial number ending in "-M"
Put your comments on an SF 368 (Quality Deficiency
(refer to regulator identification plate). .
Report). Mail it to: U.S. Army Tank and Automotive
Command, ATTN: AMSTA-Q, Warren, MI 48397-5000.
We'll send you a reply.
c. Purpose of Equipment. These generators are
high current output devices which convert mechanical
1-5. WARRANTY INFORMATION.
energy of large diesel engines into electrical power. The
regulator controls the generator output.
The generator and regulator assemblies are warranted by
the manufacturers for 12 months. Warranty starts on the
d. Superseded Manual. This manual differs from
date found on DA Form 2410 or DA Form 2408-16 in the
TM 9-2920-252-34&P (Dec 1975), which it supersedes, by
logbook. Report all defects in material or workmanship to
the addition of an updated generator (model 30B95-3-C)
your supervisor who will take the appropriate action.
and an alternate regulator (model 1300).
1-1
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |