Commutator End Plate Assembly.

TM 9- 2920- 232- 34&P / TO 38X14- 2- 32

- -

ASSEMBLY OF THE STARTER - CONTINUED

0010 00

8. Commutator End Plate Assembly.

a. Apply a light coat of grease to armature shaft (1) and on preformed packing (2). Install flat washer (3) on

commutator end of armature shaft (1) and new preformed packing (2) in groove around end plate (4).

b. Bring commutator end plate assembly (4) into position.

Use brush spring lifter tool (5) to pull brush spring (6) and raise each brush (7) onto commutator (8). Alternate

method of assembling brush holder assembly onto commutator: brush springs can be pried off brushes,

brushes raised in holder, and springs released against side of brush.

d. Apply a light coat of grease to both sides of washer (9). Install washer (9) on drive end (10) of armature shaft

(1).

e. Slide armature (11) with commutator end plate assembly (4) in place into the starter frame (12). The

maximum end play of armature shall not exceed 0.0700 inch. Align scribe marks on end plate (4) and frame

made during disassembly.

Install screws (13) and new lock washers (14) at six places to secure end plate (4) to frame (12). Torque

screws to 13--17 lb--ft (17.6 to 23.1 Nm).

0010 00- 13