|
|
![]() TM 9- 2920- 232- 34&P / TO 38X14- 2- 32
-
-
-
- -
ASSEMBLY OF THE STARTER - CONTINUED
-
0010 00
7. Lever Housing and Drive Clutch Assembly.
a. Set frame assembly (1) on end and put hose clamp (2) over plunger socket of solenoid assembly (3).
b. Bring lever housing assembly (4) into position over the frame (1), start plunger (5) into solenoid assembly (3).
Ensure that end of bellows (6) is not crimped as it slides over plunger socket when housing and frame are
brought closer together.
c.
Soak brake washer (7) in oil prior to installation into lever housing (4).
d. Apply a light coat of grease to internal spline on drive clutch assembly (8). Tilt drive clutch assembly (8) as
necessary to engage with forked end of shift lever (9).
e. Again check that bellows (6) is not crimped and ensure that new preformed packing (10) is in its groove as
lever housing (4) enters frame (1).
0010 00- 11
-
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |