Assembly - TM-9-2920-232-34-P0062

TM 9- 2920- 232- 34&P / TO 38X14- 2- 32

- -

ASSEMBLY OF THE STARTER - CONTINUED

0010 00

Assembly

1. Frame Assembly.

a. Install insulator washer (1) and insulator support (2) on terminal stud (3) of winding (4).

b. Position winding (4) in frame (5) and bring end of terminal stud (3) out through hole in frame (5) to seat

support (2).

CAUTION

When torque is applied, observe stud to keep from twisting.

Install two insulating washers (6), one metal washer (7), and hex nut (8). Torque to 20--25 lb--ft (27 to 34

Nm).

d. Install nylon sheet insulator (9) at commutator end of frame (5) so that its three large holes are aligned at

inspection holes (10) in frame (5).

e. Install three triangular insulator plates (11) at drive end of the frame. One side of each insulator must be

parallel to drive end surface of frame and point of insulator toward commutator end (12) of frame. Each of

these insulators will be positioned between the frame and one of the coil pair welded connections (13).

0010 00- 2