Using a puller from bearing puller set

TM 9- 2920- 232- 34&P / TO 38X14- 2- 32

- -

DISASSEMBLY OF THE STARTER ASSEMBLY - CONTINUED

0008 00

NOTE

Do not remove sleeve bearing to check outside diameter and housing bore diameter unless

bearing is loose in housing exceeding the 0.0040 to 0.0060 inch interference fit limits.

w. Using a puller from bearing puller set, remove sleeve bearing (35) from end plate (12). Discard bearing.

Inspect commutator end plate for cracks and distortion. Replace plate if defective.

Check bearing bore in end plate. Replace end plate if bore does not conform to 0.8740 to 0.8750 inch wear

limits.

Inspect end plate for scratches, burs, and nicks on machined surfaces. Replace if defects cannot be repaired.

aa. Inspect threads in tapped holes in end plate for damage. Replace the end plate if threads are stripped.

ab. Check inside diameter of sleeve bearing. Replace bearing if it does not conform to 0.686 to 0.689 inch limits.

ac. Inspect sleeve bearing for rough spots, score marks, scratches, and nicks. Replace if defective.

0008 00- 7