REPAIR PARTS, SPECIAL TOOLS, AND SUPPORT EQUIPMENT

TM 9- 2920- 232- 34&P / TO 38X14- 2- 32

- -

REPAIR PARTS, SPECIAL TOOLS, AND SUPPORT EQUIPMENT

THIS WORK PACKAGE COVERS:

Repair Parts, Special Tools, and Support Equipment

COMMON TOOLS AND EQUIPMENT

a. For authorized common tools and equipment, refer to the Modified Table of Organization and Equipment

(MTOE) applicable to your unit.

b. GS maintenance will have a 500 Ampere Test Stand which may be used for operation and test of starter

assembly. Refer to TM 9--4910--458--12 for information about the test stand.

Do not perform any stall test on these starter assemblies. Stall torque and current measurements are not

needed to evaluate performance.

SPECIAL TOOLS

No special tools are required to perform the maintenance procedures described in this manual.

REPAIR PARTS

Repair parts are listed and illustrated in WP 0015 00 of this manual.

ILLUSTRATED LIST OF MANUFACTURED ITEMS

Manufactured items are listed and illustrated in WP 0013 00 of this manual.

a. Brush Spring Lifter. The brush spring lifter is used to raise the brush sprinq in order to remove a brush.

b. Spring Wind Tool. The spring wind tool is used when a new brush spring is to be installed in a brush holder.

Leak Test Fitting. A leak test fitting is used for applying air pressure during the starter waterproof testing.

END OF WORK PACKAGE

0004 00-042 0-ank

00-1/ 0bl-1