Remove and discard receptacle assembly gasket

TM 9- 2920- 224- 34&P

DISASSEMBLY OF THE GENERATOR ASSEMBLY - CONTINUED

0008 00

br. Note location of indexing key (71) in receptacle assembly. Remove four screws (72) and lockwashers (73)

from receptacle assembly (74). Remove receptacle assembly from connector shell (75) using care to avoid

damage to wire leads. Discard lockwashers.

bs. Remove and discard receptacle assembly gasket (76).

bt. Remove four screws (72) and lockwashers (73) from connector shell (75) and separate shell from fan housing

(60). Discard lockwashers.

bu. Remove and discard shell gasket (76).

bv. Remove two plugs (77) from fan housing (60), two brush caps (78), and brush assemblies (79).

NOTE

Spring tension for brushes in fan motor is critical. Springs

are integral with brushes for fan motor.

bw. Check brushes and springs for cracks or breaks. New brush length shall be within 0.812 to 0.813 inch

dimension limits. Field wear limit is 0.250 inch. If any brushes or springs are defective, replace entire set.

0008 00- 18