Basic Generator Assembly-continued - TM-9-2920-224-34-P0042

TM 9- 2920- 224- 34&P

DISASSEMBLY OF THE GENERATOR ASSEMBLY - CONTINUED

0008 00

e. Remove six binding head machine screws (9) from brush leads (10).

NOTE

These screws also connect field leads to brush holders

on the electrical end bell.

Raise torsion spiral springs (11) high enough to permit electrical contact brush (12) to be lifted out by its lead,

using brush spring lifter (13). Mark brushes so they can be installed in the same brush holders, if they are not

worn beyond minimum lengths and are to be re--used. Remove all six electrical contact brushes (12) in this

manner.

g. Remove armature assembly as follows.

h. Using retaining ring pliers, expand and remove retaining ring (14) at drive end of armature shaft (8). Remove

dirt and liquid deflector (15).

0008 00- 6