 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2835-255-34
STARTER MOTOR END PLAY ADJUSTMENT (Sheet 3 of 3)
CAUTION
Holding
switch (1) ON more than 30 seconds will
damage
switch (2). Hold switch (1) just long enough
to drive
clutch motor drive gear (3) against starter
housing
collar (4).
3.
HOLD SWITCH (1) ON UNTIL SWITCH (2)
PUSHES GEAR (3) AGAINST COLLAR (4).
4.
PUSH GEAR (3) AWAY FROM COLLAR (4)
AND TRY TO SLIP 0.040-INCH GAGE
BETWEEN GEAR (3) AND COLLAR (4). IF
GAGE SLIPS BETWEEN GEAR (3) AND
COLLAR (4), SET SWITCH (1) TO OFF
AND SKIP STEP 5.
5.
PUT 0.030-GAGE BETWEEN GEAR (3)
AND COLLAR (4). IF GAGE WILL NOT
FIT, OR IS VERY LOOSE, DO STEPS 6
THRU 9.
6.
REMOVE PLUG (5). PULL GASKET (6)
OFF PLUG (5).
7.
SET SWITCH (1) TO ON UNTIL SWITCH
(2) PUSHES GEAR (3) AGAINST
COLLAR (4).
8.
PUT 0.035-INCH GAGE BETWEEN GEAR
(3) AND COLLAR (4) AND TURN LEVER
NUT (7) TO POINT WHERE GAGE JUST
SLIPS OUT. SET SWITCH (1) TO OFF AND
TURN OFF POWER SUPPLY. (8) IF END
PLAY WILL NOT ADJUST, DO STEPS 9
AND 10 AND REPLACE MOTOR (9).
9.
INSTALL PLUG (5) AND NEW
GASKET (6).
10 REMOVE CABLES (10, 11, 12) FROM
POWER SUPPLY (8) AND MOTOR (9).
11 TEST STARTER MOTOR (PAGE 9-22).
End of Task
9-42
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals