 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2835-255-34
STARTER MOTOR REPAIR (Sheet 12 of 13)
INSTALL DRIVE HOUSING (1) AND NEW
5.
GASKET (2) ON LEVER HOUSING (3).
INSTALL AND TORQUE SIX SCREWS (4,
-
5) BETWEEN 155-200 LB-IN (18-23 N-m).
"
a. Put new gasket (2) in seat (6) on lever
housing (3).
b. Line up scribe mark (7) at pipe plug (8)
on drive housing (1) with scribe mark (9)
on lever housing (3).
c. Install short screw (4) in drive housing
(1). Install five screws (5) in drive housing
(1),
d. Torque screws (4, 5) between 155-200 lb-in
(18-23 Nm).
PUT NEW PACKING (10) IN GROOVE (11)
6.
ON END BELL (12). PUT END BELL (12)
IN CAPPED VISE.
LIFT BRUSH SPRING (13) AWAY FROM
7.
BRUSH (14). SIDE BRUSH (14) OUT OF
HOLDER (15) UNTIL YOU CAN LAY
SPRING (13) AGAINST SIDE OF
BRUSH (14).
REPEAT STEP 7 FOR REMAINING SEVEN
8.
BRUSHES (14). THEN TAKE END BELL
(12) OUT OF VISE.
PULL ARMATURE (16) OUT OF MOTOR
9.
(17) UNTIL BAR RISERS (18) STICK
OUTSIDE OF MOTOR (17) AS FAR AS
POSSIBLE.
10. PUT END BELL (12) IN MOTOR (17)
UNTIL FIRST FOUR BRUSHES (14) ARE
OVER BAR RISERS (18).
Go on to Sheet 13
9-17
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals