 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2835-255-34
STARTER MOTOR REPAIR (Sheet 3 of 13)
5.
SCRIBE A STRAIGHT LINE (1) ACROSS
DRIVE HOUSING (2) AND LEVER
HOUSING (3) AT PIPE PLUG (4).
REMOVE SIX SCREWS (5). TAP DRIVE
6.
HOUSING (2) FROM LEVER HOUSING (3).
REMOVE GASKET (6).
REMOVE LEVER HOUSING (3),
7.
PREFORMED PACKING (7). OUTER
THRUST BEARING RACE (8), NEEDLE
BEARING (9), INNER BEARING RACE (10),
AND WASHER (11),
a. Tap out valve to shaft pin (12) from
housing collar (13). Pull off collar (13).
b. Remove five screws (14) and lockwashers
(15) from lever housing (3). Loosen
clamp (16).
NOTE
Clutch motor drive (17) may fall out of lever
housing (3) when lever housing (3) is taken off
winding frame (18).
c. Pry lever housing (3) from frame (18) and
solenoid switch (19).
d. Remove packing (7) from lever
housing (3).
e. Remove outer race (8), bearing (9), inner
race (10), and washer (11) from armature
shaft (20).
INSPECT PARTS FOR DAMAGE. REPLACE
8
AS REQUIRED.
9.
REMOVE STARTER MOTOR ARMATURE
(21) AND WASHER (22) FROM
FRAME (18).
REPAIR:
NOTE
If motor is found to be damaged, assemble starter
motor (page 9-16) and replace.
Go on to Sheet 4
9-8
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals