 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2835-255-34
ADAPTER AND SHAFT ASSEMBLY REPAIR (Sheet 6 of 8)
INSTALLATION:
1.
INSTALL AND SECURE SPLINED ADAP-
TER (1) ON HOLDING FIXTURE (2).
2.
INSTALL NEW METAL SEAL RING
ASSEMBLY (3) INTO GROOVE (4) OF
SPLINED ADAPTER (l), AND CHECK
THAT GAPS IN SEAL RING ASSEMBLY
ARE 180 DEGREES APART.
NOTE
Depress installed seal ring assembly (3) to allow nut
(5) to fit over seal ring assembly.
3.
COAT THREADS OF NEW RETAINING
NUT (5) WITH ANTISEIZE COMPOUND
AND INSTALL ON SPLINED ADAPTER
(l). WIPE OFF EXCESS COMPOUND WITH
RAG.
4.
USING SOCKET WRENCH (6). INSTALL
. .,
SPLINED SPUR GEAR (7), NEW KEYLOCK
WASHER (8) AND THREADED STOP (9)
ON SPLINED ADAPTER (l). TORQUE
THREADED STOP TO 50-55 LB-FT
(67.8-74.6 N-m).
a. Aline existing match marks (10). Install
splined spur gear (7) on splined adapter (1).
b. Install new keylock washer (8) on splined
spur gear (l).
c. Lubricate threads of threaded stop (9) with
lubricating oil. Use socket wrench (6) to
install threaded stop (9) in splined adapter
(l). Torque threaded stop to 50-55 Ib-ft
(67.8-74.6 N-m).
d. Deform keylock washer (8) into threaded
stop (9) at two places, 180 degrees apart.
Do not shear keylock washer.
Go on to Sheet 7
6-42 Change 4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals