 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2835-255-34
THERMOCOUPLE WIRING HARNESS REPLACEMENT ( S h e e t 2 of 2 )
NOTE
Use this task to replace any harness (l). One
harness (1) is shown.
REMOVAL:
1. REMOVE HARNESS (l).
a. Cut safety wire and remove four bolts (2)
and clamps (3).
b. Mark location of clamps (4) on harness
(1) and remove four bolts (5), self-locking
nuts (6), clamps (4), and two brackets (7).
c. Cut safety wire and remove plug (8).
d Remove harness (1) from inside of rear
module (9). Note location of marks.
2. INSPECT PARTS FOR DAMAGE. REPLACE
AS REQUIRED.
INSTALLATION:
1. INSTALL HARNESS (l).
NOTE
If harness (1) is new do step a.
a. Transfer marks made during removal to
same locations on new harness (l).
b. Push connector end (10) of harness (1)
through inside of rear module (9). Place
harness (1) on engine.
c. Apply antiseize compound to threads of
plug (8), Install plug (8) and wire to one
bolt (11).
d. Apply antiseize compound to four bolts
(2). Put on four clamps (3). Install and
wire bolts (2).
e. Put four clamps (4) and two brackets (7)
on harness (1)-at marked locations. Install
four bolts (5) and new nuts (6).
2. INSTALL FORWARD ENGINE MODULE
(GEARBOX MODULE ATTACHED)
End of Task
6-35/(6-36 blank)
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals