REAR ENGINE SUBASSEMBLY REMOVAL FROM AND INSTALLATION IN SHIPPING CONTAINER (Sheet 1 of 4)

TM 9-2835-255-34

REAR ENGINE SUBASSEMBLY REMOVAL FROM AND INSTALLATION IN

SHIPPING CONTAINER (Sheet 1 of 4)

TOOLS: General mechanic's tool kit: automotive (SC 5180-90-CL-N26)

Torque adapter (Item 23, Appendix D)

Torque wrench, 0-150 ft-lb (Item 24, Appendix D)

SUPPLIES:

Lockwasher (Item 7, Appendix E) (4 required)

Lockwasher (Item 39, Appendix E) (2 required)

Lockwasher (Item 41, Appendix E) (9 required)

Self-locking nut (Item 17, Appendix E) (8 required)

Self-locking nut (Item 42, Appendix E) (15 required)

Wood block (Item 34, Appendix B) (2 required)

Wood block (Item 35, Appendix B) (2 required)

PERSONNEL: TWO

EQUIPMENT CONDITION: Top weldment removed (page 4-1)

Engine/rear module lifting sling installed on rear engine subassembly

REMOVAL:

1. REMOVE ATTACHING HARDWARE AND

ADJUST SLING (l).

a. Remove four self-locking nuts (2), washers

(3), and screws (4).

b. Remove four self-locking nuts (5), washers

(6), and screws (7).

c. Hold eyebolt (8) from turning. Turn sling

turnbuckle (9) to level rear engine (10).

2. REMOVE REAR ENGINE (10) AND

MOUNTING FLANGE (11).

a. Lift rear engine (10) straight up and out

of bottom weldment (12). Set rear engine

(10) on four wood blocks (13).

b. Hold flange (11) and remove nine screws

(14) and lockwashers (15).

c. Remove flange (11).

Go on to Sheet 2

6-24