INSTALL RETAINING RING - TM-9-2835-255-340527

TM 9-2835-255-34

NO. 7 BEARING SEAL REPLACEMENT (Sheet 4 of 4)

WARNING

Retaining ring (1) will be under high tension during

installation. Use care when installing it.

INSTALL RETAINING RING (l).

a. Look into housing (2) and check to see if

seal (3) has been pushed far enough back

to allow retaining ring (1) to be installed in

its groove (4). If not, repeat step 1.

b. Compress retaining ring (l), and insert ring

(1) into groove (4) of housing (2).

NOTE

Rag in following step acts as a shield in case ring (1)

springs out of housing.

c. Have assistant place rag over end of

housing and retaining ring pliers, then help

to guide retaining ring (1) into groove (4).

Make sure retaining ring is properly seated

in groove (4).

d. Wipe interior of spur gearshaft (5) with

clean, dry, wiping rag. Inspect for clean-

liness.

INSTALL REDUCTION GEARBOX (PAGE

End of Task

6-22.4 Change 4