SPEED WIRING HARNESS REPLACEMENT (Sheet 1 of 1)

TM 9-2835-255-34

SPEED WIRING HARNESS REPLACEMENT (Sheet 1 of 1)

TOOLS: General mechanic's tool kit: automotive (SC 5180-90-N26)

SUPPLIES: Self-locking nut (Item 24, Appendix E) (2 required)

EQUIPMENT CONDITION: Engine disconnected from transmission (TM 34-1)

REMOVAL:

1. REMOVE HARNESS (1)

a. Remove P6 connector (2) from adapter (3)

and P36 connector 4) from adapter (5).

b. Remove two harness leads (6) from hole in

rear header (7).

c. Remove two screws (8) and selflocking nuts

(9) from two clamps (10) and two clamps (11).

Remove clamps (10) from harness (l).

d. Remove P37 connector (12) from harness).

2. INSPECT PARTS FOR DAMAGE. REPLACE

AS REQUIRED.

INSTALLATION:

1. INSTALL HARNESS (1).

a. Guide two leads (6) through hole in header

(7).

b. Install connector (2) to adapter (3) and

connector (4) to adapter (5).

c. Install connector (12) to harness (1).

d. Put two clamps (10) on harness (1) near two

clamps (11). Aline four clamps (10, 11) and

install two screws (8) and new nuts (9).

2. CONNECT ENGINE ~TRANSMISSION

(TM 34-l).

Change 2

6-4