REMOVE NO. 2 BEARING HOUSING

TM 9-2935-255-34

NO. 2 AND 3 BEARING SEAL/PACKING RETAINER REPLACEMENT (INCLUDING INTERSHAFT SEAL)

(Sheet 12 of 49)

9. REMOVE NO. 2 BEARING HOUSING (1) FROM

LOW PRESSURE COMPRESSOR HOUSING (2)

USING PULLER (3).

Install puller (3) to engage No. 2 bearing

housing (1) and rotor shaft (4).

b. Turn handle (5) of puller (3) clockwise to free

and remove No. 2 bearing housing (1).

Remove and discard preformed packings

(6,7,8).

10. INSPECT LUGS ON NO. 2 BEARING HOUSING

(1) FOR SCORING, CRACKS, OR FRETTING.

NOTE

If any of these conditions exist, the forward

engine module is not repairable at DS

level of maintenance. Reassemble forward

engine module with original hardware and

replace forward engine module (Page

Go on to Sheet 13

Change 6

5-86