NO. 2 AND 3 BEARING SEAL/PACKING RETAINER REPLACEMENT (INCLUDING INTERSHAFT SEAL) (Sheet 1 of 49)

TM 9-2835-255-34

NO. 2 AND 3 BEARING SEAL/PACKING RETAINER REPLACEMENT (INCLUDING INTERSHAFT SEAL)

(Sheet 1 of 49)

TOOLS:

General mechanic's tool kit: automotive (SC5180-90-N26)

Adapter, socket wrench, 3/4 inch male, 1/2 inch female (Item 120, Appendix D)

Arbor Press (Item 37, Appendix D)

Chain-fall hoist, 1000 pound min. capacity (Item 10, Appendix D)

Clamp, type "C" (Item 159, Appendix D)

Cotton gloves (Item 52, Appendix 6)

Crowsfoot, 1/4-inch drive, 5/16-inch (Item 206, Appendix D)

Holding fixture (Item 146, Appendix D)

Hoist, 1000 pound min. capacity (Item 11, Appendix D)

Holding fixture (Item 157, Appendix D)

Lifting sling (Item 7, Appendix D)

Micrometer, depth gage (Item 205, Appendix D)

Remover/installer tool, #2 & 3 seals (Item 160, Appendix D)

Puller, #2 bearing housing (Item 204, Appendix D)

Puller, No. 3 brg hsg (Item 161, Appendix D)

Puller, bevel gear (Item 153, Appendix D)

Sleeve set (Item 162, Appendix D)

Sling (Item 163, Appendix D)

Socket, 3/8-inch drive, 7/32-inch, 12 point (Item 191, Appendix D)

Spanner wrench (Item 164, Appendix D)

Spanner wrench (Item 165, Appendix D)

Torque wrench, 0- 150 lb-in (Item 27, Appendix D)

Torque wrench, 0-200 lb-ft (Item 166, Appendix D)

PERSONNEL: Two or three

SUPPLIES:

Antiseize compound (Item 2, Appendix B)

Cotter pin (Item 5, Appendix E)

Dry cleaning solvent (Item 7, Appendix B)

Dry Moly Kote "Z" (Item 53, Appendix B)

Gasket (Item 1, Appendix E) (2 required)

Locking cup (No. 3 bearing) (Item 172, Appendix E)

Lockwasher (Item 120, Appendix E) (28 required)

Lubricating oil (Item 11 or 12, Appendix B)

Marker (grease) pencil (Item 54, Appendix B)

Non electric wire (Item 15, Appendix B)

Plastic sheet (Item 55, Appendix B) (approx. 4 ft square)

Go on to Sheet 2

Change 6

5-75