INSTALL ACCESS COVER PLATE

TM 9-2835-255-34

NO. 1 BEARING SEAL/PACKING RETAINER REPLACEMENT (Sheet 20 of 21)

Using care, turn low pressure compressor

blades (1) by hand and listen and feel for rub-

bing or binding. No rubs or binds should be

felt and no unusual noises should be heard.

NOTE

If any of these conditions exist, inlet hous-

ing (2) should be disassembled as re-

quired to locate and correct problem.

Safety wire six bolts (3) making sure not to run

safety wire over three access cover bolt holes

(4). Use double twist method.

24. APPLY SHORTENING COMPOUND TO PRE-

FORMED PACKING (5) AND INSTALL IN BEARING

HOUSING LOW PRESSURE COMPRESSOR SPEED

PICKUP HOLE (6).

25. INSTALL ACCESS COVER PLATE (7) AND SE-

CURE WITH THREE BOLTS (8). TIGHTEN BOLTS (8)

BETWEEN 40-45 LB-IN (4.5-5.1 NM) TORQUE.

SAFETY WIRE BOLTS (8) USING SINGLE WIRE

METHOD.

LE5519

Go on to Sheet 21

Change 6

5-73