REMOVE HIGH PRESSURE CASE AND STATOR ASSEMBLY (BOTTOM HALF)

TM 9-2835-255-34

LOW PRESSURE ROTOR AND HOUSING ASSEMBLY (COMPRESSOR) AND HIGH PRESSURE

AXIAL COMPRESSOR AND ROTOR CLEANLNG (Sheet 11 of 21)

19.

REMOVE HIGH PRESSURE CASE AND

STATOR ASSEMBLY (BOTTOM HALF) (1).

`..

Remove 16 bolts (2) and lock washers (3)

from air diffuser (4).

Remove 14 bolts (5) and nuts (6) from

housing (7).

Have assistant support high pressure case

and stator assembly (bottom hall) (1), and

remove two bolts (8) and nuts (9) from

each side.

Remove high pressure case and stator

assembly (bottom half) (1) from engine.

20.

REPEAT STEPS 3 THROUGH 7. AND

CLEAN LOW PRESSURE CASE AND

STATOR ASSEMBLY (BOTTOM HALF) (1).

REPEAT STEPS 3 THROUGH 7. AND

21.

CLEAN HIGH PRESSURE CASE AND

STATOR ASSEMBLY (BOTTOM HALF) (1),

22.

PREPARE NEW BATCH OF CLEANING

SO1.UTION BY MIXING ONE PART OF

ALKALINE DESCALER COMPOUND TO

FOUR PARTS OF FRESH HOT WATER.

Go on to Sheet 12

5-44 Change 4