INSTALL NEW GASKET - TM-9-2835-255-340400

TM 9-2835-255-34

FORWARD ENGINE MODULE (GEARBOX MODULE ATTACHED) REMOVAL

AND INSTALLATION (Sheet 5 of 7)

3. INSTALL NEW GASKET (l).

a. Apply shortening to gasket (1), three

rings (2), and shaft (3).

b. Install gasket (1) in groove (4) on rear

module (5).

4. INSTALL FORWARD MODULE (6) ON

REAR MODULE (5).

a. Turn handle (7) clockwise until forward

module (6) is close to shaft (3).

b. Aline forward module (6) with shaft (3).

Turn handle (7) until forward module (6)

is close to rear module (5).

c. Using alinement pin (8) in forward

module (6) and small holes (9) in rear

module (5) as reference to 12 o'clock

position, aline studs (10) to mating

holes (11).

d. Turn handle (7) clockwise until forward

module (6) is mated to rear module (5).

NOTE

Tighten bolts (12) and nuts (13) at top, bottom, and

each side of engine first to seat forward module (6)

on rear module (5).

e. Apply antiseize compound to 81 bolta (12).

Install bolts (12) and new nuts (13).

f. Apply antiseize compound to 15 studs

(14). Install 15 new nuts (15) on studs

(14).

TORQUE BOLTS (12) AND NUTS (13, 15)

BETWEEN 170-190 LB-IN (19-22 Nm).

Go on to Sheet 6

5-29