Installation. - TM-9-2815-224-34-P0453

TM 9-2815-224-34&P

Water Pump Maintenance Instructions (Cont)

Apply compound No. 2 to threads of shaft (3).

(17)

Soldier A installs impeller (13), washer (14), and locknut (15).

(18)

Hold 0.015 in. (0.38 mm) feeler gage between impeller (13)

(19)

and corner (16) of pump body (5).

While holding feeler gage in position described in step (19),

(20)

turn impeller (13) and wall of pump body (5).

If clearance is wrong, repeat section b. Disassembly and

(21)

section c. Cleaning/Inspection of this procedure.

Installtion.

Install ring seal (1) on water pump (2).

(1)

Install water pump (2) on front cover (3) and into

(2)

two hoses (4) and (5).

Install screw (6) and washer (7). Tighten screw to

(3)

20 to 25 lb-ft (27 to 34 Nm).

Install screw (8), lockwasher (9), and washer (10).

(4)

Tighten screw to 20 to 25 lb-ft (27 to 34 Nm).

NOTE

Some engines do not have screw, lockwasher,

and clip. Refer to TM 9-2320-279-24P.

Install screw (11), lockwasher (12), and clip (13).

(5)

Change 2