Adjustment. - TM-9-2815-224-34-P0441

TM 9-2815-224-34&P

Engine Governor Maintenance Instructions (Cont)

NOTE

Some older model engines have one washer and do not have a bracket.

Screw that goes through bracket is longer than the others.

Install two screws (20), three washers (21), spacer washer (21.11, four lockwashers (22), and

(9)

nuts (23).

Install screw (24), lockwasher (25), and ground wire (17).

(10)

Install washer (26) and nut (27) finger tight and take slack out of bracket (4).

(11)

Tighten nuts (27) and (29) against bracket (4).

(12)

c. Adjustment.

Hold lever (1) in run position.

(1)

Adjust nut (2) to touch bracket (3).

(2)

Tighten nuts (2 and 4) against

(3)

bracket (3).

Move lever (1) to stop position; if it

(4)

binds, loosen mounting bolts and realine

Follow-on Maintenance.

Connect batteries (TM 9-2320-279-20).

(I)

Start engine and check operation of

(2)

engine stop switch (TM 9-2320-279-10).

Shut off engine (TM 9-2320-279-10).

(3)

Install engine cover (TM 9-2320-279-20).

(4)

Install engine side panel

(5)

(TM 9-2320-279-10).

END OF TASK

15-41/(15-42 blank)

Change 2