 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2815-224-34&P
Engine Governor Maintenance Instructions (Cont)
d. Assembly.
NOTE
Assembly pertains to Model A switch
only.
Silver end of wire is installed on
center screw on switch.
Install two screws (1), lockwashers (2),
(1)
diode wire (3), lockwasher (4), and two
terminals (5) on switch (6).
Install two screws (7), washers (8),
(2)
clamp (9), diode wire (10), switch (6),
bracket (11), and clamp (12) finger-tight.
NOTE
The switch should close when the gage is
inserted.
Adjust gap between bracket (11) and
(3)
switch (13). Gap between bracket and
switch must be 0.010 in. (0.254 mm).
Tighten two screws (7).
(4)
Install plunger (14) in plunger
(5)
assembly (15).
(6)
Install spring (16), washer (17), and
retaining ring (18).
Install nut (19), locknut (2O)
(7)
locking ring (21), and preformed
packing (22).
15-29
Change 2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals